Mesh clarification

Options
HARIHARSUDEN.V
HARIHARSUDEN.V Member Posts: 1

When ANSYS starts to create a mesh, i would like to know from which point it starts forming the mesh. Whether it will start from some corner or from centre? From base to top or from top to bottom. This is being asked as in any meshing there are some unsymmetrical meshes induced in between.

Comments

  • Mike.Thompson
    Mike.Thompson Member, Employee Posts: 279
    First Anniversary First Comment 5 Likes Ansys Employee
    Options

    This forum is for scripting issues. For general questions on modeling check out ANSYS Innovation Soace.
    Also please indicate on that post what applications you are referring to for meshing.