Why do I get warning message when I import Q3D model into ansys circuits?

It says

**_Cannot create dynamic link component for design 'Mainfile' in 'C:/Users/.../Documents/Ansoft/XYZ.aedt'. Linked designs must have solutions.

_**

I can run this cosimulation even after this but I am not sure if the simulation is correct. My doubt is because of this message I get every time I place Q3D model into ANSYS circuit.

My workflow:
1. Ran Q3D parasitic extraction with a sweep from 0Hz to 20Mhz
2. Saved the solution
3. Went to Ansys circuits to import the Q3D model and connected the pins rightly using page connectors
4. While placing the model I get the message
5. I ran the transient simulation at 50kHz fsw and got the results

I doubt something is wrong because I am not getting desired ringing which I expected during switching instances. For 50kHz fsw 20Mhz of sweep shall be enough I think.

So is this message a real problem or something I can ignore safely for now?

Find more posts tagged with

Q3D Extractor

Accepted answers

All comments

James Derrick

Hi @Bishwas B. thanks for your question. This forum is specifically for questions regarding scripting and/or development using Ansys Developer tools. If you have a scripting question please include some details regarding code you have tried and documentation you have already considered. Otherwise you might find more luck over on the Ansys Innovation Space forum, which is specifically for non-developer questions.