What's this Warning about? I'm simulating a centrifugal pump
WARNING: The wall motion has a significant normal component on 37090 faces of face zone 22.
The maximum angle between the velocity and face surface is 87.2 deg at (-2.588e-01, -1.501e-02, 5.599e-02).
The tolerance for this check is controlled by the rpvar 'wall/vnormal-tolerance'.
Please check your setup. This warning will not be written again.
Tagged:
0
Answers
-
Hello, this forum is dedicated to scripting questions. For any other questions, please use the Innovation Space Forum: https://innovationspace.ansys.com/forum/ (be aware that Ansys empl. are not allowed to download any attached files in the forum), or contact your local Ansys support provider.
0
